FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
Back to site

M48 AUX V sensor setup

 
Post new topic   Reply to topic    EFI University Forum Index -> MoTeC
View previous topic :: View next topic  
Author Message
ONQRACING



Joined: 23 Mar 2008
Posts: 62
Location: SE PA

PostPosted: Sat Aug 04, 2012 5:37 am    Post subject: M48 AUX V sensor setup Reply with quote

I am running an M48 and need to set up the aux V for a Motec 8 Bar Pressure transducer (PNM P155-2230) which will have its value displayed on a Pista dash. We have it wired into Pin 18 for signal and the 0 and 5V pins are also functioning. Our issue is in the set up in the Motec Software. We have it set as a -3 value, and have the cal table populated with some values provided by motec east. When running the engine at idle, we see a reading, but if we blip the throttle, and the pressure rises, it will show a ----- value after reading around 15000 as a value.

Seems we are way off on something?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    EFI University Forum Index -> MoTeC All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group

©2007 EFI University
Website designed and maintained by 3LizardsMedia.com