EFI University

[bandit67]

We are selling our Dynojet 224xLC chassis load dyno (with Eddy Current Brake)

Dyno is currently hooked up and fully operational, so photos and/or videos could be made available
Measures up to 1800 hp and 180mph
Eddy Current Load Absorption Unit, Torque Cell, and dynamic load control software. Perform loaded tests, including step, sweep, and wind drag simulation.
A simple click of the mouse or keyboard can turn the 224xLC from an eddy current dynamometer back into an inertia only dynamometer or vice versa

Includes all of the following items:
• optional Above Ground Kit
• 2 module stacks - includes one new spare stack, current one being used was serviced by Dynojet in Spring 2012
• Automatic Conditions Measurement (absolute pressure, air temp, humidity)
• WinPEP7 Software and Hardware to interface (software updated by Dynojet Dec 2011)
• Gateway Desktop Dyno Computer, 20” flat screen monitor, keyboard, mouse, wifi card (new Dec 2011) Craftsman workbench for computer & equipment (stationary, dark gray metal, with metal top) - All computer cables, surge protector, and all Dynojet cables included for proper, immediate hookup
• Ignition Wire Inductive Tachometer Pickup Leads (Primary & Secondary leads, both new Dec 2011), spare functioning Secondary Lead
• Auto Tie Down Package (straps, ratchets and ground hooks – 2nd complete set of rachet straps & axle straps new Dec 2011)
• Four Rubber Chocks (2 new Dec 2011)
• Air Actuated Brake System (new brake pads installed Spring 2012)
• Remote Software and Brake Control from Driver's Seat (2nd brand new remote pendant included)
• Spare Bosch Air/Fuel Sensor
• also included: FAST EZ Clamp-On Tailpipe Wide-Band Sensor Mount Kit
• Optical RPM Pickup
• Brand new, unused Analog Module included
• 2 blower fans
• Installation manuals, operation manuals, and software tutorial
• Includes 4 prong 220V twist lock plug power cable for Eddy Current cell

This dyno is fully operational and includes everything necessary to be hooked up and running at its new location immediately. Date of manufacture was April 2005. Asking $26,500.
If buyer wants the 12k lb Rotary 4-post lift that we are currently using with the dyno in its above ground setup, price for the entire package is $29,000. Lift will fit up to a crew cab long bed pickup.

Contact Ed at 720-536-5365 in Denver, Colorado