buzzinhalfdozen
Joined: 30 Mar 2006
Posts: 74
|
 Posted: Thu Apr 19, 2012 5:15 am Post subject: Autronics Model; B analyzer |
 |
|
| Have an Autronics Model B that has no output for datalogger, have made required connections at 9 pin connector as per instructions. While using DVOM set to DC volts scale in function7 I see no voltage between term.4 and 9, believe it should show 1 volt also tried between term. 4 and 5 no voltage shown, believe it should show 5 volts. I noticed that if i go between ground and either pins 4,5 or 9 I show 7.92 volts, this seems wrong. Maybe I'm testing this incorrectly but I believe there's an issue with the unit. Where could I have this repaired? Thanks for any replies. Joe Buchanan |
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
