EFI University
Electronic Fuel Injection Tuning Forum
|
| View previous topic :: View next topic |
| Author |
Message |
N2OGUY
Joined: 25 Feb 2007
Posts: 7
|
 Posted: Tue Nov 23, 2010 10:14 am Post subject: MAP calibration |
 |
|
| A 1 BAR sensor should read about 4.83 volts at 100KPA. You should see close to this voltage at key on. The voltage set points accross the bottom of the MAP calibration table should be 0, .71, 1.43, 2.14, 2.86, 3.57, 4.29, and 5. The MAP KPA set points along the left side should go from 0 - 105 KPA. These settings should give you a reading of about 90-100KPA at key on. |
|
| Back to top |
|
 |
Jacthono3
Joined: 28 Feb 2011
Posts: 3
|
| Posted: Mon Feb 28, 2011 11:53 pm Post subject: |
|
|
I have the new module installed
-----------------------------------------
nfl jerseys cheap nfl jerseys |
|
| Back to top |
|
|
Jacthono3
Joined: 28 Feb 2011
Posts: 3
|
| Posted: Mon Feb 28, 2011 11:53 pm Post subject: |
|
|
I have the new module installed
-----------------------------------------
nfl jerseys cheap nfl jerseys |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
©2007 EFI University |
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
