| View previous topic :: View next topic |
| Author |
Message |
msimard
Joined: 04 Dec 2008
Posts: 17
Location: Dacula, GA
|
 Posted: Sat Jul 31, 2010 6:23 am Post subject: LC-1 output settings for Motec logging |
 |
|
Could someone please tell me the settings program an LC1 for to be able to log wideband on an M48?
The first thing I tried based on vague memories was 0v=0L, 5v=5L but it wouldn't accept those numbers.
On the Motec, isn't there something like setting for narrowband?
I had mine setup but it lost it's settings after installing a new sensor and all mention of settings seems to have disappeared from the internets! That's funny because I think I once detailed the procedure on either the Motec or Innovate forum and now it's gone and I'm helpless. |
|
| Back to top |
|
 |
msimard
Joined: 04 Dec 2008
Posts: 17
Location: Dacula, GA
|
| Posted: Sat Jul 31, 2010 7:49 pm Post subject: |
|
|
Well, .5v=.5L and 1.5v=1.5L seems to work.
I hope posting this hidden knowledge doesn't make this forum disappear too!  |
|
| Back to top |
|
|
Matt Cramer
Joined: 25 Sep 2007
Posts: 278
|
| Posted: Mon Aug 02, 2010 8:01 am Post subject: |
|
|
| msimard wrote: | Well, .5v=.5L and 1.5v=1.5L seems to work.
I hope posting this hidden knowledge doesn't make this forum disappear too! |
Correct, that's the default setting for an LC-1 on Analog 2, out of the box. The LC-1 can be configured for other output curves as well; some users run 0 volts at 10:1 AFR and 5 volts at 20:1 AFR for more resolution in the areas engines typically run.
_________________
Matt at DIY Autotune |
|
| Back to top |
|
|
ONQRACING
Joined: 23 Mar 2008
Posts: 61
Location: SE PA
|
| Posted: Fri May 27, 2011 6:50 pm Post subject: LC-1 |
|
|
| So, the M48 will operate with those broader ranges? I too am running the Innovate on my M48, Logworks shoes good readings, but the M48 sees blank, wires are good, pins are good, nerves are shot... |
|
| Back to top |
|
|
ONQRACING
Joined: 23 Mar 2008
Posts: 61
Location: SE PA
|
| Posted: Sat May 28, 2011 11:15 am Post subject: |
|
|
| Be sure your M48 is set up to log the Lambda, a setting of 3 will cause the LA to not be logged, as was the case here.. All is well now.. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
